CALCULAR A QUE ALTURA PUEDE SUBIR EL AGUA


Comments

Post a Comment

Popular posts from this blog

STRUCTURAL DETAILING

  Resources Instructions Drawings Credits Module 1:  Detailer Training Series Introduction (No Quiz) PART 1a Module 2:  Plain Materials & Construction Documents PART 2a PART 2b PART 2c Module 3:  Bolting & Welding PART 3a PART 3b Module 4:  Beams Without Bracing Connections PART 4a PART 4b PART 4c PART 4d Module 5:  Girders PART 5a PART 5b Module 6:  Columns PART 6a Module 7:  Vertical Bracing PART 7a PART 7b PART 7c Module 8:  Horizontal Bracing PART 8a Module 9:  Sundry Items, Girts, Stiffeners, Skewed Beams Bracing PART 9a PART 9b Module 10:  Good Detailing Practices PART 10a PART 10b Module 11:  Final Exam
Read more

CAMBER

Image
  Cold cambering is the most common method used in fabrication shops to induce camber in a steel member, as it is a simpler and more cost-effective method than heat cambering.  This method uses a mechanically induced force to achieve the desired curvature. The member (I – beam) is placed in a device called a cambering machine that is often built by the fabricator but is also commercially available. The cambering machine consists of two restrained pivots, one near each end of the beam and one or two hydraulic jacks near the middle of the beam.  The jacks apply a force to induce camber into the member. After placing the member at the restrained end pivots, the rams of the hydraulic jack or jacks are advanced to apply stress into the member past it’s yield point to produce a permanent deflection. When the rams are retracted, the residual deformation remains.  The beam may need to be moved back and forth to actuate the jacking forces at different locations along the leng...
Read more